Tube drawing with tilted die : texture, dislocation density and mechanical properties

Al-Hamdany, Nowfal; Salih, Mohammed Zakria; Palkowski, Heinz GND; Carradò, Adele; Gan, Weimin GND; Schell, Norbert; Brokmeier, Heinz-Günter GND

Anisotropic behavior is a key characteristic for understanding eccentricity in tubes. In this paper, the effect of using a tilted die during tube drawing on eccentricity, texture, dislocation density, and mechanical properties is shown. Copper tubes were drawn with a ±5◦ tilted die for two passes. The increase or decrease in eccentricity can be controlled by controlling the angle of the tilted die. Two types of textures have been developed during tube drawing, namely plane strain and uniaxial types. Plain strain type texture is mainly characterized by the β fiber with a dominant copper component {112}<111>. The uniaxial deformation type is dominated by the <111> fiber, as commonly found by wire drawing. Texture sharpness increases with increasing drawing strain, and the texture varies significantly between the maximum and minimum wall thickness. This texture variation between maximum and minimum wall thickness has no significant influence on mechanical properties, which are more or less similar, but the increase in strength after each drawing pass is apparent. The dislocation density is low for the as-received tubes due to recovery and recrystallization. This is consistent with the as-received texture dominated by the cube component {001}<100>. During tube drawing, dislocation density increases as a function of the deformation strain. The variation of dislocation density between the maximum and minimum wall thickness in the tube deformed with −5◦ tilted die is higher than the variation in the tube deformed with +5◦ tilted die.



Al-Hamdany, Nowfal / Salih, Mohammed Zakria / Palkowski, Heinz / et al: Tube drawing with tilted die. texture, dislocation density and mechanical properties. 2021.


12 Monate:

Grafik öffnen


Nutzung und Vervielfältigung: